ST-LINK/V2 除錯器 | 燒錄器 | 下載器 | 仿真器

ST-LINK/V2 除錯器 | 燒錄器 | 下載器 | 仿真器
The ST-LINK/V2 is an in-circuit debugger and programmer for the STM8 and STM32
microcontrollers. The single-wire interface module (SWIM) and JTAG/serial wire
debugging (SWD) interfaces are used to communicate with any STM8 or STM32
microcontroller located on an application board. In addition to providing the same
functionalities as the ST-LINK/V2, the ST-LINK/V2-ISOL features digital isolation
between the PC and the target application board. It also withstands voltages of up to
1000 Vrms.
STM8 applications use the USB full-speed interface to communicate with the ST
Visual Develop (STVD-STM8) or ST Visual Programmer (STVP-STM8) software, or with
integrated development environments from third-parties.
STM32 applications use the USB full-speed interface to communicate with the
STM32CubeIDE software tool or with integrated development environments from
third-parties.
《特色》
 5 V power supplied by a USB connector
 USB 2.0 full-speed compatible interface
 USB Type-A to Mini-B cable provided
 SWIM specific features:
 1.65 V to 5.5 V application voltage support on the SWIM interface
 SWIM low-speed and high-speed modes support
 SWIM programming speed rates: 9.7 kbyte/s in low-speed, 12.8 kbyte/s in
high-speed
 SWIM cable for connection to an application with an ERNI standard
connectorVertical connector reference: 284697 or 214017Horizontal
connector reference: 214012
 SWIM cable for connection to an application with pin headers or 2.54 mm
pitch connector
 JTAG/serial wire debug (SWD) specific features:
 1.65 V to 3.6 V application voltage support on the JTAG/SWD interface and
5 V tolerant inputs
 JTAG cable for connection to a standard JTAG 20-pin 2.54 mm pitch
connector
 JTAG support
 SWD and serial wire viewer (SWV) communication support

 Direct firmware update support (DFU)
 Status LED blinking during the communication with the PC
 Operating temperature from 0 °C to 50 °C
 1000 V rms  high isolation voltage (ST-LINK/V2-ISOL only)